Face the back side of the sticker upwards and while placing your middle fingers on the opposite side of the area where ① is printed, pull it sideways.
This time, while placing your middle fingers on the opposite side of the area where ② is printed, pull it sideways.
Fold the areas where ① is printed (top and bottom sides) perpendicularly.
Fold the areas where ② is printed (left and right sides) perpendicularly.
Now, a frame is created so you can place the cigarette pack at the right place.
Insert the cigarette pack, front side facing down, between the frames.
Remove all the release papers where ①, ②, ③, and ④ are printed.
Using a flat surface, stick the side of the cigarette pack to the sticker.
When doing so, apply pressure on the surface using the edge (black arrows in the figure) of the cigarette pack.
Stick the left and right side of the cigarette pack to the sticker.
Apply the ‘wings’ of the sticker to the cigarette pack.
Similarly, using a flat surface, stick the cigarette pack (top and bottom side) to the sticker.
Apply the ‘wings’ of the top and bottom side of the sticker to the cigarette pack.
Finally, remove the remaining release paper and stick the back side of the pack to the sticker.
Face the backside of the sticker upwards and while placing your middle fingers in the center, pull it sideways.
When applying the sticker on a slim cigarette pack, fold the release paper around the two inner dotted lines.
Now, a frame is created so you can place the cigarette pack at the right place.
When applying the sticker on a slim cigarette pack, fold the release paper around the two outer dotted lines. Now, a frame is created so you can place the cigarette pack at the right place.
Insert the cigarette pack, top side facing down, between the frames.
Insert the cigarette pack, top side facing down, between the frames.
Remove both release papers.
Using a flat surface, stick the side of the cigarette pack to the sticker. When doing so, apply pressure on the surface using the edge (black arrows in the figure) of the cigarette pack.
If you cannot use a flat surface, gently pull down the sticker and apply it on the pack using your thumb and index finger.
Use your thumb nail to cut open the sealed part. Warning: the sealed part will not cut nicely if the pack is empty.